Hoshizaki KM-320MAH-E Manual De Instrucciones página 2

ENGLISH
IMPORTANT
1. This booklet is an integral and essential
part of the product and should be kept and
preserved by the user. Please read carefully
the guidelines and warnings contained herein
as they are intended to provide the user
with essential information for the continued
safe use and maintenance of the product. In
addition, it provides GUIDANCE ONLY to the
user on the correct services and site location
of the icemaker. Please preserve this booklet
for any further consultation that may be
necessary.
2. This is a commercial icemaker, and should
be destined only to be used for the purpose
for which it has been expressly designed
and attached to a suitable storage bin as
specified by Hoshizaki. Any other use should
be considered improper and therefore
dangerous. The manufacturer will not be held
liable or responsible for any damage caused
by improper, incorrect and unreasonable use.
I. Installation Instructions
WARNING
The installation must be carried out by
qualified personnel, in accordance with current
regulations, according to the manufacturer's
instructions.
1. Location
IMPORTANT
1. This icemaker is not intended for outdoor
use. Normal operating ambient temperature
should be within +7°C to +40°C. Normal
operating water temperature should be within
+7°C to +35°C. Operation of the icemaker,
for extended periods, outside of these normal
temperature ranges may affect production
capacity.
2. The icemaker should not be located next to
ovens, grills or other high heat producing
equipment.
3. The location should provide a firm and level
foundation for the equipment.
4. Allow 15 cm. clearance at rear, sides and
top for proper air circulation and ease of
maintenance and/or service should they be
required.
5. This appliance is not suitable for installation
in an area where a water jet could be used
and where dripping is not allowed.
6. Do not place anything in front of the louver.
7. This icemaker will not work at subfreezing
temperatures. To prevent damage to the
water supply line, drain the icemaker when
air temperature is below zero.
2. Electrical Connection
WARNING
THIS APPLIANCE MUST BE EARTHED
This icemaker requires an earth that meets the
national and local electrical code requirements.
To prevent possible severe electrical shock to
individuals or extensive damage to equipment,
install a proper earth wire to the icemaker. Turn
off the power supply before any maintenance,
repairs or cleaning is undertaken.
• This icemaker must have a separate power supply
or receptacle of proper capacity. See the nameplate.
It is recommended that this icemaker be the only
electrical device on its power supply circuit.
• Stacked icemakers should each have a separate
receptacle.
• Usually an electrical permit and services of a licensed
electrician are required.
• If a power cord and/or a plug should need to be fitted/
replaced, it should only be done by a qualified service
engineer.
• Factory fitted power cords are coloured in accordance
with the following code:
Green & Yellow = Earth
Blue = Neutral
Brown = Live
(Plugs and power cords are not supplied with the
KM-1301SAH-E.)
For the U.K. and the Republic of Ireland Only
• The non-rewirable plug must never be used without a
fuse cover being fitted.
• The correct replacement for the detachable fuse
cover is identifiable from the manufacturer's reference
number stamped on the plug.
• Supply of replacement fuse covers can be obtained
from Hoshizaki Parts/Service Centres.
• Fuses should be rated at 13A and approved to
BS 1362.
For KM-1301SAH-E only
A suitably sized power supply cord (see the rating on
the nameplate) must be fitted by a qualified installer
into the terminal box on the rear of the machine. The
wires in the terminal box are coloured in accordance
with the following code:
Green & Yellow = Earth
Blue = Neutral
Brown = Live
2