Recommendations And Safety Precautions; 2- Preparing The Swimming Pool; Adding Salt To The Water - BSV BS POOL N-BSSALT Manual De Usuario

1.3- Recommendations and safety precautions

- The equipment should always be installed by qualified staff.
- Disconnect the equipment from the mains before performing any
assembly or maintenance operation.
- Make sure that the electrical installation has all compulsory
protection elements (circuit breaker and differential switch) in
perfect condition.
- It is important to ensure that the supply cables of the
electrolysis cell are tightly connected, otherwise the
equipment could overheat and break down.
- Ensure that the heatsink wings (in the rear part of the
equipment) are not blocked and that air can easily circulate through
them.
- All the BSV equipment incorporate protection systems against short
circuits in the cell, absence of water detector and other safety systems
that give an acoustic and visual alarm in the event of any anomaly.
However, for optimum results, you should ensure the correct hydraulic
operation of your swimming pool.
- Equipment housing has IP65 protection. However, it is highly
recommended not to install the equipment directly exposed to sunlight.
- Corrosive environments may reduce the lifespan of the equipment. Do
not leave open containers with acids near the equipment.

2- PREPARING THE SWIMMING POOL

2.1- Adding salt to the water

To ensure that the chlorinator works correctly, a small amount of salt should be
added and the pH level should be suitable.
The recommended salt and pH levels are the following:
N-BSSALT
Although the equipment will start to operate with lower amounts of salt, the
optimum production of salt will be reached with concentrations of over 4kg/m3.
We recommend a concentration of 5Kg/m3 to offset small losses of salt
occurring when cleaning the filter, the effect of rainfall, etc.
N-BSSALT V3.0
Salt Concentration
(g/l)
4 a 6
pH
7,1 a 7,4
25 / 57