5- Maintenance; Cleaning The Electrolysis Cell - BSV BS POOL N-BSSALT Manual De Usuario

5- MAINTENANCE

Carefully follow the recommendations and safety warnings detailed in section
1.4 of this manual.
The chlorinator has a self-cleaning system of the chlorination cell, which
reduces maintenance considerably.
Bear in mind that the electrolysis cell will wear out through use. If after
cleaning, the equipment does not work normally, the cell should be replaced.
Your dealer will be able to advise you on the need to change this element.

5.1- Cleaning the electrolysis cell

The electrolysis cell should be cleaned in the following circumstances:
- If the low level of salt indicator comes on and the concentration is
correct.
- If the overload indicator comes on and the level of salt is correct.
- If lime scale is observed on the surfaces of the electrodes. In this case,
the equipment can also be adjusted so that the frequency between each
automatic cleaning operation is less. This frequency will depend on the
hardness of water in your area.
Submerge the cell in a hydrochloric acid solution, or use a commercial product
to clean electrolysis cells (CELLCLEAN). Do not use sharp objects that could
damage the titanium coating of the electrodes.
N-BSSALT V3.0
37 / 57