DISPLAY
OFF
START
PELLET FEEDING
IGNITION
START UP
WORK
MODULATION
BURN POT CLEANING
AUTO CLEANING
FINAL CLEANING
STAND BY
EXT STAND BY
COOLING STAND BY
COOLING STDBY
BLACK OUT
STAND BY
RE IGNITION
LOW
HOT
CLOSE
TANK DOOR
56
REASON
Stove o
The start phase is in progress
Pellet feeding during the ignition phase is in progress
The ignition phase is in progress
The start phase is in progress
The normal work phase is in progress
The stove is modulating
The automatic burn pot cleaning is in
progress.
The automatic burn pot cleaning is in progress caused by the temperature in the chamber.
When the stove is switched-o , nal cleaning is in progress. The nal cleaning phase lasts about 10
minutes.
Stove o due to temperature reached
and in stand-by for re-ignition.
Stove o due to an external
thermostat, in stand-by for re-ignition
A new ignition is attempted when
the stove has just been switched-o
The stove is cooling due to black out
The stove is in stand-by for re-ignition.
Room thermostat set at minimum
value.
Room thermostat set at maximum
value.
Pellet tank open.
Door open.
Air vent clogged or dirty.
DISPLAYS
The automatic burn pot cleaning (not in 1st power) is performed
at pre-established intervals of continued working.
To deactivate the STAND-BY function see the speci c chapter.
To deactivate the STAND-BY function see the speci c chapter.
When the stove switches o , it is necessary to wait until complete
fumes motor switch o and then clean the burn pot.
The stove can only be re-ignited when these operations have
been performed.
On completion of the cooling phase, it will re-ignite automatically.
In this mode the stove only works at 1st power independently
from the power set. To exit this function just raise the room
temperature using button 4 and then key 2.
The stove works at the set speed, without ever modulating. To exit
this function just lower the set temperature using button 4 and
then key 1.
Check the correct closure of the door and pellet tank.
Check air vent.
ENGLISH
SOLUTION
-
-
-
-
-
-