AEG SCB61921FS Manual De Instrucciones página 13

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
The compressor operates
continually.
The compressor does not
start immediately after
pressing the "FROSTMAT-
IC", or after changing the
temperature.
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The "FROSTMATIC" is
switched on.
The water drainage plug is
not correctly positioned.
Temperature is set incor-
rectly.
This is normal, no error has
occurred.
Food products prevent the
water to flow into the wa-
ter collector.
The water outlet is clog-
ged.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The "FROSTMATIC func-
tion" is switched on.
The temperature regulator
is not set correctly.
ENGLISH
Solution
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait few hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "FROSTMATIC func-
tion".
Position the water drainage
plug in the correct way.
Refer to "Operation" .
The compressor starts after a
period of time.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water out-
let to the evaporative tray.
Switch off "FROSTMATIC
function" manually, or wait un-
til the resets automatically to
set the temperature. Refer to
"FROSTMATIC function".
Set a higher/lower tempera-
ture.
13

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido