CEMB SM628 Manual De Uso página 13

- Find the pneumatic supply 8 mm diameter pipe from the lubrication filter inside the
machine.
- Cut the pipe at about half its length fig.5.
- Connect the T-union supplied with the 8 mm diameter pipe of the machine fig.6.
- Mount the side casing.
CALIBRATION OF THE ACCESSORY
If you notice some anomaly in the operation DO NOT use the tyre changer and
call the technical assistance service immediately.
- Lock a medium-sized rim with a central hole on the turntable.
- Insert the rim pressing tool cone on the arm (fig.7), pushing upwards until it clicks into
place.
- Bring the device arm to its working position, with the rotating arm at its travel limit.
- Use the specific command to lower the arm so you can check that the cone is perfectly
centred in relation to the rim hole (fig.7).
If it isn't, proceed as follows:
- Loosen the bolts that fix the auxiliary device to the bracket. Rotate the auxiliary device
slightly and check the centring of the cone on the rim again.
- If it still isn't centred, insert additional thickness spacers between the bracket and the
base to correct the tilt and ensure the correct centring.
User's manual
5
WARNING
EN
6
7
13