CEMB SM628 Manual De Uso página 31

6.4.2 Mounting of the support on the rim
(Procedure for Pax System with full-width rest)
- Place the selector (E) on position 1 fig. 48
- If not present, mount the cylindrical roller on the arm fig.48a
- Move the arm axially until the cylindrical roller is brought into position, flush with the
rim fig. 48
- Press the roller onto the bead of the tyre, and at the same time rotate the turntable until
the rest (S) is fully inserted in the rim (T) fig. 48
- At completion lift the roller off the tyre.
6.4.3 Mounting the rest on the rim
(Procedure for Pax System with clipé rest)
- Mount the double roller tool (J) in fig. 49
- Move the arm axially until the roller with the greater diameter is brought in position,
flush with the rim
- Remove the tyre bead, bring the roller down to the surface of the rest while keeping
the bead behind the special claw on the double roller tool fig.50
- Rotate the turntable until the rest (S) is fully inserted in the rim (T). At completion lift
the roller off the tyre.
User's manual
S
45
T
46a
R
T
46
47
EN
31