Accessmatic Avanti 4000Z Manual De Usuario página 39

vanti
Opening your life
11. Installation of the belt x plate
1. Remove the screw A, take o the C.
2. Cut the belt according to the belt cutting.
Screw B (M5)
3.Hang belt to belt wheel of each side.
4.Adjust the short belt tension with reference to the adjustment of the bell tension.
5. Tighten screw A, make the C and B xed together.
6. Put the E as shown in the gure, keep belt horizontally.
7. Fix The E onto track (Attention: The position of belt install plate should not a ect
Screw A (M5)
door operation).
Belt
Belt of C
12. Installation of the motor
1. Put respectively four square screws in grooves number 1 and 2 before installing
the motor.
2. According to the graphical position fasten the motor on the track by four square
screw. Then put spring washer and tighten mounting nuts.
Caution: Driving wheel on the motor must de ect towards the inside of the track.
11