Accessmatic Avanti 4000Z Manual De Usuario página 42

vanti
Belt in the belt connector A
Belt in the belt connector B
15. Adjustment of idler pulley
1• Loosen the four fastening screw and adjusting screw to make the adjustment plate in the far right (adjustable range of the tension
increase).
2, Put belt into the driving wheel of the motor on one side and into driving wheel of the pulley on the other side. Adjust the three square
screws. Make the belt tight as far as possible, then tighten the three nuts to x pulley
3. Turn the adjusting screw clockwise with socket head (MS) so that the adjusting plate will be moved to the right and the belt tension
increased gradually. Adjusting the belt tension to tighten four fastening screw suitably.
Fastening screw
Adjusting plate
Opening your life
Adjusting screw
14