INSTALLATION
WARNING
Take the utmost care when unpacking, assembling, lifting and setting up the machine
as indicated below.
Failure to comply with these instruction may damage the machine and risk the opera-
tor's safety.
Remove the original packaging materials after positioning them as indicated on the
packaging and keep them for possible future shipping.
Installation clearances
ATTENTION (for radio versions only)
Before starting with installation, make sure that no machines working with the same fre-
quency band are located within a radius of 200m from the selected installation spot.
In the case of interference, request a different frequency band.
WARNING
The regulations in force concerning safety at work must be complied with when choos-
ing the installation position.
The floor must be able to support a load equal to the sum of the weight of the equip-
ment plus the maximum load allowed, taking into consideration also the resting base
and any fixing means envisaged.
Position the machine in a manner that guarantees access to all four sides� In particular,
check the minimum space required for the work indicated in Fig� 6:
- at the front for wheel loading and unloading;
- at the rear to be able to view the work being performed�
IMPORTANT: for correct, safe use of the equipment, we recommend a lighting level of
at least 300 lux in the place of use�
WARNING
If the machine is installed outdoors, it must be properly sheltered under a roof.
Work environment conditions
- Relative humidity: 30-95% without condensation
- Temperature range: 0° — +55°
WARNING
Use of the machine in a potentially explosive atmosphere is not permitted.
Positioning on the ground
Before proceding with any operation, it is recommended to level the machine on the
ground using the adjustable feet (fig�7) to ensure better stability when working� In the
case of very heavy wheels, it may be necessary to further adjust the feet� This will prevent
any jerking from the rear part of the base�
42
Operator's manual MONSTER AGTT