Display Signal And Error Table - Corghi MONSTER AGTT Manual De Uso

SERVICE Flashes slowly
MODE
FACTORY Variable
MODE status based
on the com-
mands given
Table 1 – Operating modes

DISPLAY SIGNAL AND ERROR TABLE

During normal mode, some errors could occur that are described in table 2� The error
code is shown on the display� Some errors prevent some machine automatisms from being
used (i�e� errors E00 and E01) or cause them to stop early (i�e� error E11)�
Pressing the Clear key on the control panel cancels the error code on the display but if
the cause of the error is not removed and the command that generated it is repeated,
the message will reappear
ERROR # MEANING
E00 No calibration data
E01 No signal on analogue channel
#1 (radial movement measure-
ment potentiometer)�
E02 No signal on analogue channel
#2 (channel currently not used)
E03 No signal on analogue channel
#3 (channel currently not used)
E04 No signal on analogue channel
#4 (analogue laser for the Side
To Side)
Operator's manual MONSTER AGTT
Flashes On
upon arrival steady if the
of the com- cable
mands is con-
nected;
otherwise off
Flashes On
upon arrival steady if
of the the cable
commands is con-
nected;
otherwise
off
Variable Technical
messages service
personnel
Variable Factory
messages personnel
ACTION
Calibrate the machine� If
the error remains replace the
board CPU-RX2�
This signal appears also
when a new board is
installed�
Check the connection of the
potentiometer and its condition�
If the error persists contact
technical assistance�
Check the connection of the
laser and its condition� Check
that the glass on the front of
the laser is not dirty� If the error
persists contact technical
assistance�
This operating
mode includes the
global correction
Setting and Calibra-
tion programmes�
UK
61