Electrical Connections - Riello Burners RS 190 Instrucciones De Instalación, Funcionamiento Y Mantenimiento

Quemadores de gas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

(A)
RS 190 without leak detection control device
(B)
RS 190 with leak detection control device VPS
(C)
RS 190
230 V 400 V
F
A
T25
T20
2
L
2,5
2,5
mm
(D)

ELECTRICAL CONNECTIONS

Use flexible cables according to EN 60 335-1
Regulations:
• if in PVC sheath, use at least H05 VV-F
• if in rubber sheath, use at least H05 RR-F.
All the wires to connect to the burner terminal
strip 9)(A) must enter through the supplied fair-
leads.
The fairleads and hole press-outs can be used
in various ways; the following lists show one
possible solution:
1 - Pg 13,5 Three-phase power supply
2 - Pg 11
3 - Pg 11
D955
4 - Pg 9
5 - Pg 13,5 Gas valves
6 - Pg 13,5 Gas pressure switch or gas valve
7 - Pg 11
8 - Pg 9
LAYOUT (B)
Electrical connection RS 190 burners with-
out leak detection control device.
LAYOUT (C)
Electrical connection RS 190 burners with
VPS leak detection control device.
Gas valve leak detection control takes place
immediately before every burner start-up.
Fuses and cables cross-section layouts (B) and
(C), see table (D).
Cross-section when not indicated: 1,5 mm
D956
KEY TO LAYOUTS (B - C)
IN - Burner manual stop switch
XP- Plug for leak detection control device
MB- Burner terminal strip
PG- Min. gas pressure switch
S - Remote lock-out signal
S1 - Remote lock-out signal of leak detection
TR- High-low mode load remote control system:
TL - Load limit remote control system:
TS - Safety load control system:
VR- Adjustment valve
VS- Safety valve
D957
10
Single-phase power supply
Remote control device TL
Remote control device TR
leak detection control device
Open the hole, if a pipe union is to
be added
Open the hole, if a pipe union is to
be added
control device
controls operating stages 1 and 2.
If the burner is to be set up for single stage
operation, replace of remote control device
TR with a jumper.
shuts down the burner when the boiler tem-
perature or pressure reaches the preset
value.
operates when TL is faulty
2
.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

3785813835 t1

Tabla de contenido