Dimensions Of The Control Module; Connecting The Device - Mectron COMPACT PIEZO LED Manual De Instalación

WARNING: Do not install the device in
places where there is a risk of explosion.
The device cannot operate in environments
where anesthetic or flammable mixtures
are present.
CAUTION: The electrical contacts inside
the cord and handpiece connectors must
be dry. Before connecting the handpiece
04.2 Û DIMENSIONS OF THE CONTROL MODULE
04.3 Û CONNECTING THE DEVICE
CAUTION: Do not, for any reason, invert
the scaler cord red wire position with
the scaler cord black wire position on the
connector.
CAUTION: In case of need of longer
wires for the connection to the power
Connect the purple and the grey wires to the CN2 connector and the black and red wires on the
M2 clamp respecting the correct polarity.
Purple
Grey
M2
Red
Black
CN2
04 Û INSTALLATION
to the cord, make sure that the electrical
contacts of both connectors are perfectly
dry, especially after the sterilization cycle
in autoclave. If need be, dry the contacts by
blowing compressed air onto them.
WARNING: Only use original Mectron
inserts, accessories, and spare parts.
fastening of control
supply, always use wires with an adequate
diameter, as for example 1,5mm 2 .
CAUTION: Do not cable the scaler cord
red and black wires together with other
wires.
scaler handpiece cord
Blind holes for
module
9
EN