Battery Inspection - Benelli BN302 Manual Usuario

EN

BATTERY INSPECTION

To access the battery compartment:
1. Remove the saddle using the
wrench provided.
2. Remove the 4 screws "A" fastening
the battery bracket "B" and remove it.
3. Take out the battery "C".
A
B
Cleaning the terminals
•
Once the saddle has been removed,
check the condition of the terminals
"D" and "E".
If they are oxidised, remove the
battery and clean them with a metal
brush.
• After cleaning the terminals apply a
light layer of grease before refitting
the battery.
We recommend using Petronas Tutela
protection grease.
C
Turn the key to "
the battery.
When the battery is removed, the
negative (Black) terminal must be
disconnected before the positive one
(Red). When the battery is reitted, the
positive pole must be connected irst.
Connect the nuts to the terminals.
Once the battery has been inspected,
reit the saddle following the steps in
reverse order.
https://www.motorcycle-manual.com/
E
D
NOTE:
" before accessing
102
Battery storage.
The battery tends to discharge if not
charged on a regular basis. When the
battery is completely lat, chemical
reactions occur inside it that will damage
it irreparably.
IMPORTANT NOTICE:
If the vehicle is not being used for more
than 15 days, the battery must be
removed, charged monthly and stored in
a cool, dry place. If the battery is left on
the vehicle, disconnect the negative
electrode (Black).
If the above precautions are not taken,
the battery becomes damaged,
This damage is not covered by
guarantee.