26
INSTALLATION
4
3
6
1. Remote control grommet
2. Battery cord grommet
3. Clutch cable
5
4. Extension cord
5. Throttle cable
6. Cord assembly B
7. Battery cord
2. Detach the throttle and shit cable joints
by removing the R-pins.
2
1
1. R-pin
2. Throttle cable joint
3. Shift cable joint
Screw the tip of the remote control
cable into the cable joint up to approx.
10 mm (0.39 inch), then lock them with
a lock nut. Here, apply grease to the
hole of the cable joint.
1
5
7
2
ENOF02309-0
3
ENOF02310-0
3. Move the remote control lever to the
" F O R W A R D "
"REVERSE" positions to confirm that
the shift is working properly, then set
the lever to "NEUTRAL".
2
1
1. Remote control cable
2. Lock nut
3. Cable joint
4. Approx. 10 mm (0.39 in)
4. Double-check that the remote control
cables (i.e., the throttle cable and shift
cable) have been connected correctly.
Move the remote control lever forward
to the first point at which it engages
(approx. 32°). The cable which moves
first when the lever is turned should be
the shift cable. Check that the shift
lever is in "NEUTRAL" position and that
the free throttle lever is fully closed
when the remote control cables have
been connected.
4
1. Free throttle lever
2. Fully opened
3. Fully closed
°
4. Approx. 32
" N E U T R A L "
a n d
3
3
4
ENOF02311-0
2
1
3
ENOF02312 1