Operating Mode Configuration; Programming Work Time (Motor Mode) - Vimar ELVOX ECGF Manual De Instrucciones Para La Conexión Y El Uso

ECGF

4. Operating mode configuration:

The micro control panel is factory set in motor mode.
In any case, be sure not to connect an electric motor with the micro control panel set in lights
mode because it could simultaneously power both windings of the motor.
Caution!
Note: Running this procedure will delete all the remote controls in memory!
Step Action
1 Press and hold down P1 for more than 3 s
Keep on pressing and holding down P1 for
more than 3 s
3 Release P1 and press it to select the setting
of the micro control panel as per the buzzer
signal.
4 Press and hold down P1 for more than 3 s to
end the procedure

5. Programming work time (motor mode):

Step Action
1 Press P1
2 Press and hold down P1 for more than 3 s
3 Press P1 as many times as the desired number
of minutes of motor activation:
1 press => 0 minutes
2 presses => 1 minute
.....
60 presses => 59 minutes
4 Confirm the minutes of operation by keeping P1
pressed for more than 3 s
5 Press P1 as many times as the desired number
of seconds of motor activation:
1 press => 0 seconds
2 presses => 1 seconds
.....
60 presses => 59 seconds
6 Confirm the seconds of operation by keeping P1
pressed for more than 3 s to end the procedure
Note: If the time is not confirmed, the previously set time is kept.
Note: If you set a time of 0 min and 0 s, the default time of 4 min and 0 s is automatically set.
VIMAR group
Signal
The buzzer will beep
> 3 s
The buzzer will beep
> 3 s
m = 1 beep
m = 2 beeps
x n
The buzzer will beep
> 3 s
Signal
The buzzer will beep once
every 2 s
x 1
The buzzer will beep
> 3 s
The buzzer will beep 3 times
whenever the button is
pressed
x n
The buzzer will beep
> 3 s
The buzzer will beep 4 times
whenever the button is
pressed
x n
The buzzer will beep
> 3 s
EN
=> Lights mode
=> Motor mode
x 1
x 1
x m
x 1
x 1
x 1
x 3
x 1
x 3
x 1
13