Deleting A Single Remote Control; Deleting All The Remote Controls; Setting The Default Parameters - Vimar ELVOX ECGF Manual De Instrucciones Para La Conexión Y El Uso

ECGF

10. Deleting a single remote control:

Step Action
1 Press and hold down P1 for more than
3 s
2 Wait (approx. 0.5 s) for the buzzer signal.
3 Press P1 at the 5th beep
4 Press the remote control button to delete
5 To delete other remote controls, repeat
from point 4
6 Wait for the 10 s timeout to exit the
procedure

11. Deleting all the remote controls:

Step Action
1 Press and hold down P1 for more than 3 s
2 Wait (approx. 0.5 s) for the buzzer signal.
3 Press P1 at the 4th beep
4 Successful deletion is signalled by the
buzzer

12. Setting the default parameters:

Note: Setting the default parameters carries out the following operations:
- Deletion of all the saved remote controls
- Setting the motor operating mode
- Configuration of the outputs to bistable
- Setting the motor timing to 4 min and 0 s
Step Action
1 Press and hold down P1 for more than 3 s
2 Wait (approx. 0.5 s) for the buzzer signal.
3 Press P1 at the 3rd beep
4 Restoring the default settings is signalled
by the buzzer
18
Signal
The buzzer will beep
> 3 s
The buzzer will start emitting 5 beeps
x 1
The buzzer will beep 5 times to signal
deletion
... 10 s ... The buzzer will beep
Signal
The buzzer will beep
> 3 s
The buzzer will start emitting
5 beeps
x 1
The buzzer will beep 5 times
Signal
The buzzer will beep
> 3 s
The buzzer will start emitting
5 beeps
x 1
The buzzer will beep 3 times
EN
x 1
x 1
x 5
x 5
x 1
x 1
x 5
x 1
x 5
x 3