mabe IO65HI Manual De Instrucciones página 32

instructions for installation
The appliance must be connected to the gas system by a rigid metal
pipe (copper or steel) or continuous wall stainless steel flexible hose
in such a way that the appliance is not stressed in any way.
· The appliance gas inlet tube has
an end nut to which is connected
the elbow union (supplied; 1/2
thread male gas). It can be turned
depending on installation needs.
· The flexible stainless steel supply
pipe (Max. 1 mt) is connected
to the part opposite the elbow
union. Remember to put the
gaskets supplied at the two ends
of the elbow union.
When these parts are disassembled and reassembled, always replace
he gaskets with new ones. Once the appliance is installed, check that
the gas pipe is not pinched or damaged by mobile parts.
Important: when installation is complete, check that all the gaskets
are leaktight using a soap-based solution, never a flame.
adaptation of oven burner to the different types of gas
To fit the equipment to the different types of gas from the one it has
been preset, (see the label set on the packing and on the equipment),
operate as follows:
· Open the oven door and remove all the inside
accessories (basin, grid, etc)
· Lift and remove the oven sole.
· Remove the burner by turning the screws set
on the burner front fixing triangle.
· Turn highwards to remove the burner from
the support holding the rear injector to gain
access to the injector to be replaced with the
new one supplied. Use a 10 mm wrench. (See
"Table of the characteristics").
· Reverse the above mentioned operations
to reassemble the several elements and
rememberto replace the calibration label
set on the equipment with the new label
supplied.
Pipe ramp
Nut
Gasket
Elbow union
Gasket
Nut
Rigid or flexible metal
supply pipe
32