Notes about the remote control
Precautions when using the remote control
o When using the remote control, point it toward the remote con-
trol signal receiver on the main unit from a distance of 7 m (23 ft)
or less. Do not place obstructions between the main unit and the
remote control.
o The remote control might not work if the remote control signal
receiver is exposed to direct sunlight or bright light.
o Beware that use of this remote control could cause the unin-
tentional operation of other devices that can be controlled by
infrared rays.
Installing batteries
1
Slide the bottom end of the remote control as
shown in the illustration, and pull out the bat-
tery holder.
2
Insert two AA batteries with ¥ and ^ ori-
ented as shown in the holder, and put the
holder in again.
3
Slide the bottom end of the remote control as
shown in the illustration to close the battery
holder.
When to replace batteries
If the distance required between the remote and the main unit
decreases or if the main unit stops responding to the remote buttons,
replace both batteries with new ones.
Dispose of the used batteries according to the instructions on them
or requirements set by your local municipality.
V
Precautions concerning batteries
Misuse of batteries could cause them to rupture or
leak, which might result in fire, injury or the staining of
nearby materials.
Please read and observe the precautions on page 4
carefully.
15