Waeco PerfectView CRT245 Instrucciones De Montaje Y De Uso página 45

RV-245.book Seite 45 Freitag, 25. November 2005 4:25 16
PerfectView CRT245
Attaching the camera holder using self-tapping screws
No. in fig. 9, page 10
A
B
Self-tapping screws may only be used:
for attaching the holder to sheet steel with a minimum thickness of 1.5 mm.
Observe the following when making the drill holes into the sheet metal:
– Check beforehand that there is sufficient room for the drill head to emerge
once the holes have been made.
– Using a hammer and centre punch, make a small dent to prevent the drill
head from slipping.
– Grind all drill holes and provide them with rust-protection.
➤
Drill a hole of Ø 4 mm on the previously marked points.
➤
Screw the camera holder on using 5 x 20 mm self-tapping screws (see fig. 10.B,
page 11).
Attaching the camera holder using threaded bolts
No. in fig. 9, page 10
D
E
When making the attachment with threaded bolts:
Observe the following when making the drill holes:
– Check beforehand that there is sufficient room for the drill head to emerge
once the holes have been made.
– When tightening the nuts, ensure that they cannot be pulled through the
dashboard (you may have to use bigger washers or plates).
➤
Drill a hole of Ø 5.5 mm on the previously marked points.
➤
Screw the camera holder on using M 5 x 20 mm threaded bolts (see fig. 10.C,
page 11).
Quan-
Parts required
tity
1 Camera holder
2 Self-tapping screws 5 x 20 mm
Quan-
Parts required
tity
1 Camera holder
2 Threaded screws M 5 x 20 mm
with nuts and washers
Mounting the external camera
45