medi circaid juxtafit essentials leg Instrucciones De Uso página 5

Note:
Once the correct pressure is set using
the BPS card, you may fold the top and
bottom part of the circaid undersleeve
over the top and bottom edge of the
circaid juxtafit garment.
Recommendation for combination of
lower and upper leg with knee
garments:
If combining a circaid juxtafit essentials
lower leg with a circaid juxtafit
essentials upper leg with knee, ensure
that the upper leg with knee overlaps
with the lower leg.
Doffing the circaid® juxtafit®
essentials upper leg with knee:
Step 1: Detach all bands of the legging
starting with the top band. Fold each
band onto itself to keep the Velcro tabs
lint-free.
Step 2: Remove the garment and then
remove the circaid undersleeve.
Donning the circaid® juxtafit®
essentials knee cover:
For additional compression in the knee
area apply the circaid juxtafit essentials
knee cover. Place the circaid juxtafit
essentials knee cover across the knee
cap and attach it to the garment. Pull
the bands in varying directions to
achieve a snug fit across the knee.
Doffing the circaid® juxtafit®
essentials knee cover:
To remove the circaid juxtafit essentials
knee cover detach all Velcro tabs and
remove the knee cover from the
garment.
Using the Built-In-Pressure card:
It is recommended to always use the
BPS card packaged with the product.
Step 1: Locate the Built-In-Pressure card
in your packaging.
Step 2: Starting with the bottom band,
line up the black triangle on the card
with one of the BPS lines on the bottom
band.
Step 3: Note where the second BPS line
lines up with the card´s compression
ranges.
Step 4: If the BPS line on the garment
either falls short (Fig. B) or goes beyond
the correct compression range (Fig. C),
readjust the band as necessary so that
the second BPS line on the garment is
aligned with the prescribed compression
range (Fig. A). Completely loosen the
band before reapplying it if too much
tension has been applied.
Step 5: Repeat the steps 2 - 4 for each
band going up the leg. Be sure to adjust
all bands to the same compression level.
Bands may need adjusting throughout
the day to maintain the prescribed
compression range.
Note
If using multiple circaid juxtafit
made-to-measure garments, only lightly
apply bands overlapping the legging
below to ensure gradient compression.
Set the remaining bands to firm and
comfortable compression or prescribed
compression level.
English
English