afx light DMX512-PRO Manual De Instrucciones página 14

9. Press the button SCENE and then the button REC to memorize the scene.
10. Select the desired memory bank with one of the number buttons 1-16.
• If necessary, use the button PAGE to switch between the two channel groups 1-16
(LED A lights) and 17-32 (LED B lights).
• To confirm the memory procedure, all LEDs of the controller flash three times.
11. Repeat the steps 2 to 10 to memorize further scenes.
12. After all desired scenes have been memorized, switch off the programming
mode. For this, keep the button REC pressed until the LED above the button lights.
Calling Illumination Scenes
Static scenes from the memory bank can only be used in manual mode.
1. There should be no device selected. If one of the control LEDs of the number
buttons 1- 16 light, press the corresponding button for deselecting.
2. Press the button SCENE.
• The control LED lights.
3. Call the desired scene with the number buttons 1-16.
• The control LED lights.
• If the button is pressed once again, the scene is deselected (control LED
extinguishes).
• If necessary, use the button PAGE to switch between the two channel groups 1-16
(LED A lights) and 17-32 (LED B lights).
Adjusting Fade In for the Color Channels
Manual
Fig. 7.6 Adjusting a fade in time
Fade 8.5S
It is possible to adjust a fade in time for illumination scenes affecting the RGBW color
channels 1-4 and the dimmer channel. When actuating a sliding control, the
corresponding channel is moved slowly and steadily to its target value. The controller
automatically creates all necessary intermediate values. Keep the button FIXTURE
pressed and simultaneously adjust the fade in time with the pan wheel between 0-30
seconds. When turning the wheel, the display indicates the selected value in the
lower line, e.g. "Fade 8.5S" for a fade in lasting 8.5 seconds.
Deleting Illumination Scenes
Program
Fig. 7.7 Programming mode
©Copyright Lotronic 2018 Manual DMX512-PRO 14