afx light DMX512-PRO Manual De Instrucciones página 21

• The display shortly indicates "SAVE OK" and returns to the main menu level.
RDM DMX Address setup [RDM DMX address assignments]
This menu allows identifying connected RDM devices and changing their DMX
address assignment.
1. Call the menu item with the pan wheel and confirm with ENTER.
2. Select the setting [YES] with the pan wheel to access RDM functions and confirm
with ENTER.
3. The controller starts searching for RDM devices. The display indicates e.g.
"DISCOVER COUNT005" when five devices have been found.
4. Select the desired device with the pan wheel. The display indicates information
regarding the device in the upper line and the corresponding DMX address in the
lower line.
5. Use the tilt wheel to change the DMX address and confirm with ENTER.
6. Press the button SWAP to indicate the UID (manufacturer ID and serial number) of
the device in the upper line of the display.
7. Press the button BLACK OUT to perform the identify function for the device.
8. After your settings, return to the main menu level with ESC.
Regarding RDM
RDM stands for "Remote Device Management" and makes remote control of devices
connected to the DMX bus possible. RDM is an extension of the DMX512 protocol.
RDM is especially useful when the device is installed in a remote area.
RDM is integrated in DMX without influencing the connections. RDM data is
transmitted via the standard XLR pins 1 and 2 and does not require a new cable type.
RDM-ready and conventional DMX devices can be operated in one DMX line. If DMX
splitters are used, they must support RDM.
Data backup [Data backup]
All settings of a light show, i.e. DMX settings, illumination scenes and chases can be
stored on a USB memory device and recalled later. 16 memory banks are available.
1. Connect a USB memory device to the controller's USB port.
2. Call the menu item with the pan wheel and confirm with ENTER.
3. Select the setting [YES] with the pan wheel confirm with ENTER. The display
indicates "Press number key Select file" (select memory bank with number button).
4. Select a memory bank with one of the number buttons 1-16. The display indicates
e.g. "FILE:1" and a progress bar.
• Each memory bank must be stored separately. If the control LED of a number button
lights, this memory bank has been stored on the USB memory device before.
• The data will be stored in the folder "DMX Move Control 512" located on the root
directory of the USB memory device. A file with the extension "PRO" will be created
©Copyright Lotronic 2018 Manual DMX512-PRO 21