Safety Cautions - Gima QUICK 240 Manual De Uso Y Mantenimiento

Thanks to the special materials used, the design characteristics and the air circulation system on five
sides of the equipment, allow the sterilizer to operate all working day. However for energy saving, it is
recommended to keep the cover closed when the equipment is ready but it is not working.
A periodical control of the sterilization process is also recommended, using the sterilization indicator
strips or similar products on the market.
Recommended sterilization times
Files, probes, mirrors, phial tubes
Cotton, paper tips, surgical tools
Curettes, clamps, burs, handpieces, contra-angles
Maintenance and repair
Always check the power is unplugged before maintenance is carried out. The glassbeads must be
periodically replaced, when they lost their transparency. To replace the glassbeads, the container must
be pulled out when the sterilizer is completely cold. The sterilizer needs no particular maintenance,
provided the adequate environment are satisfied, except for a regular cleaning of its external parts. It
is recommended to clean the equipment with a soft cloth and wate or mild detergents. Regularly check
if the power cable is in good conditions. It is possible to replace the safety fuse pulling out the fuse
block at the rear. Please always follow the characteristics stated in the technical data sheet. If the
sterilizer doesn't work properly, contact the manufacturer or the authorized service. If any repairs are
needed, please return the equipment directly to the manufacturer or to the local distributor using only
the original package. However it is possible to contact specialized technicians, who must work in
accordance to general safety and accident prevention rules of the country in which the equipment is
installed.
Out of order
No particolar cautions.
This equipment must be used only by authorized personnel thoroughly familiar with the correct use.
The sterilizer must be used only for its designed purpose:
to sterilizer surgical instruments or tools in the medical and paramedical field. The sterilizer
must not be used for all treatments concerning contact lenses (Rule 15 - All.9 - Comma 1).
It is necessary to take all precautions to avoid unauthorized use. Do not modify, change or put out of
order any electrical or thermal safety protection of the equipment.
When the sterilizer is operating, pay attention to the people near the equipment.
The user must not attempt to carry out any repair unless authorized.
Do not clean or repair the sterilizer while it is connected to an electrical system and be sure the container
is at room temperature. Regularly check if the power cable is damaged.
When authorized technicians decide to replace spare parts, they must use original replacements and
moreover they must adhere to the manufacturer's information and technical characteristics. In case of
any doubt about safety rules, please contact the manufacturer or local distributor before using the
equipment.
However use the sterilizer in accordance with the general safety and accident prevention rules of the
country in which the equipment is installed.
TABLE "A"

SAFETY CAUTIONS

8
5 sec.
5-10 sec.
10-15 sec.