Hilti SF 2-A Manual De Instrucciones página 14

Wear protective clothing and wash exposed areas with soap and
water. Allowing dust to get into your mouth, eyes, or to remain on your
skin may promote absorption of harmful chemicals.
5.3.2 Power tool use and care
a) Secure the workpiece. Use clamps or a vice to secure the work-
piece. The workpiece is thus held more securely than by hand and both
hands remain free to operate the power tool.
b) Check that the insert tools used are compatible with the chuck
system and that they are secured in the chuck correctly.
c) Large and heavy insert tools must only be operated in first gear.
There is otherwise a risk that the tool will be damaged when it is switched
off or, under unfavorable conditions, the chuck might be detached.
5.3.3 Battery tool use and care
a) Ensure the switch is in the off position before inserting battery pack.
Inserting the battery pack into power tools that have the switch on invites
accidents.
b) Do not expose batteries to high temperatures or fire. This presents
a risk of explosion.
c) Do not disassemble, squash or incinerate batteries and do not sub-
ject them to temperatures over 80°C (176°F). A risk of fire, explosion
or injury through contact with caustic substances may otherwise result.
d) Avoid ingress of dampness.Dampness may cause a short circuit
resulting in a risk of burning injury or fire.
e) Use only batteries that are approved for use with the applicable tool
or appliance. Use of unapproved batteries or use of the batteries for
areas of application for which they are not approved presents a risk of
fire and explosion.
Observe the special instructions applicable to the transport, storage
f)
and use of Li-ion batteries.
g) Remove the battery before storing or transporting the power tool.
h) Avoid short-circuiting the battery. Check that the terminals on the
battery and in the power tool are free from foreign objects before
inserting the battery in the power tool. Short circuiting the battery
terminals presents a risk of fire, explosion and chemical burns.
i) Do not charge or continue to use damaged batteries (e.g. batteries
with cracks, broken parts, bent or pushed-in and/or pulled-out
contacts).
j) If the battery gets too hot to touch, this may indicate that it is faulty.
Place the tool in a location where it can be kept under observation,
Printed: 24.03.2014 | Doc-Nr: PUB / 5174907 / 000 / 00
en
11