Before Use; Charging The Battery; Fitting The Battery - Hilti SF 2-A Manual De Instrucciones

6 Before use

6.1 Battery use and care
NOTE
Battery performance drops at low temperatures. Use the tool only after
fully charging the battery. This ensures that maximum battery capacity is
available. Change to the second battery in good time. Recharge the battery
immediately so that it is ready for reuse.
Store the battery in a cool, dry place. Never store the battery where it is
exposed to the heat of the sun, on a radiator or behind glass, e.g. at a
window. Batteries that have reached the end of their life must be disposed
of safely and correctly to avoid environmental pollution.

6.2 Charging the battery

DANGER
Use only the Hilti batteries and Hilti chargers listed under "Accessories".
6.2.1 Charging a new battery for the first time
Charge the battery fully before using it for the first time.
6.2.2 Charging a previously used battery
Ensure that the outer surfaces of the battery are clean and dry before
inserting it in the corresponding charger.
Information about charging can be found in the operating instructions for
the charger.
Lithium-ion batteries are ready for use even when only partially charged.

6.3 Fitting the battery

CAUTION
Before fitting the battery, check that the power tool is switched off and
that the safety lock is engaged (forward/reverse switch in the middle
Printed: 24.03.2014 | Doc-Nr: PUB / 5174907 / 000 / 00
en
13