Power Stroke PS80310E Manual Del Operador página 18

„ Squeeze the trigger and wait approximately 5 seconds
for the detergent to appear.
„ Spray the detergent on a dry surface using long, even,
overlapping strokes. To prevent streaking, do not allow
detergent to dry on the surface.
Before shutting off the engine:
„ Fill the soap tank with clean water.
„ Spray the clear water through the spray wand until the
tank is empty.
„ If any detergent remains in the spray, repeat with a second
tank of clean water.
„ Shut off the engine.
NOTE: Shutting off the engine will not relieve pressure in the
system. Pull trigger to release water pressure.
RINSING WITH THE PRESSURE WASHER
„ Turn off the pressure washer and shut off the water supply.
Pull trigger to release water pressure.
„ Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
„ Remove the soap nozzle by placing hand over nozzle then
pulling back the quick-connect collar. Place soap nozzle
in the nozzle storage area on the machine.
„ Select the right nozzle for the job. See the chart on the
previous page for selecting the appropriate nozzle.
„ Start at the top of the area to be rinsed and work down,
overlapping the strokes.
MOVING THE PRESSURE WASHER
See Figure 20.
NOTE: Never lift or carry this product using the handle and
never place the unit in any position other than upright on
its wheels.
„ Turn the pressure washer off.
OPERATION
„ Tilt the machine toward you slightly until it balances on
the wheels then roll the machine to the desired position.
Do not tilt forward or sideways when moving.
„ DO NOT attempt to move the unit by pulling on any of
the hoses.
USING PUMP PROTECTOR
See Figure 21.
Regular use of a commercially available pump protector
prolongs the life of the pressure washer by removing hard
water mineral deposits, lubricating pump seals and pistons,
and preventing freeze damage. Pump protector should
be added to the unit after every use and before storage.
Pump protector can be purchased at the retailer where you
purchased your pressure washer, or by calling customer
service.
The instructions that follow are typical for adding pump
protector but you should always verify the specific instructions
provided by the manufacturer of the pump protector used.
„ Turn off the pressure washer engine and shut off the water
supply. Pull trigger to release water pressure.
„ Disconnect garden hose and high pressure hose.
„ Unscrew threaded top from pump protector bottle and
remove paper seal from bottle. Reinstall top on bottle and
tighten securely.
NOTE: The rubber seal should remain inside the threaded
top. If it comes out, be sure to replace before reinstalling
the top.
„ Remove bottle cap and attach threaded end of bottle
securely to pressure washer pump water intake.
„ Squeeze bottle to inject contents into pump.
„ With engine switch in the OFF position, pull starter grip
and rope to cycle pump, then squeeze bottle again to
guarantee complete coverage.
„ Pump is protected when the protector fluid exits the pump
outlet.
Page 14 — English