Tools Needed For Assembly And Alignment - Bosch TC10 Instrucciones De Funcionamiento

BM 2610019162 10-11:BM 2610019162 10-11.qxp 10/20/11 8:59 AM Page 11
Nut Wrench
(Included)
K
l
Hex Wrench
(Included)
Assembling the Motor/Support Arm Assembly
NOTE: Your TC10 has been calibrated by the
factory. If the blade appears to be misaligned, follow
the adjustment procedure on pages 17 &18.
1. Position the motor/support arm assembly onto the
frame assembly (Fig. 1).
2. Using the hex wrench supplied, install the four bolts
and tighten (Fig. 1).
3. Then place the four bolt covers on the bolts.
Assembly

Tools Needed for Assembly And Alignment

Framing square
FIG. 1
-11-