Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2610019162 10-11:BM 2610019162 10-11.qxp 10/20/11 8:59 AM Page 17
Bevel Cut Adjustment
The saw is adjustable to three bevel angles: 0°,
22 .5°, and 45°. The three grooves in the work table
accommodate the three bevel-cut positions.
1. Loosen the bevel-cut-adjustment knob in the rear
of the saw (Fig. 21).
2 . Tilt the saw to the desired angle (0°, 22.5° or 45°).
Tighten the bevel-cut-adjustment knob.
Universal Guide Adjustment
The universal guide can be used as a rip fence or
an angle guide. The universal guide has three pos-
itive stops: 0°, 22.5°and 45°.
To adjust the Universal Guide:
1. Loosen the lever on the universal guide.
2. Adjust the universal guide so that the desired
angle (0°, 22.5°, 45°) aligns with the indicator
arrow (Fig. 22). Tighten the lever to lock the uni-
versal guide at the desired angle.
For straight cutting, the universal guide is used as
rip fence (Fig. 23).
Adjustments
FIG. 21
SIDE OF UNIVERSAL
GUIDE
GROOVE EDGE
1. Set the angle to 0°.
2. Loosen the universal-guide lock knob and position
the guide to the desired distance from the saw
blade, and lock in place.
Rail Adjustment / Blade Alignment
NOTE: The saw has been calibrated by the manu-
facturer. The following adjustment steps are to be
used only when necessary.
1. Turn off the saw. Remove the two end covers (1)
at the ends of the rails. Remove the two top cov-
ers (2) of the rails by sliding them out from the top
of the rails (Fig. 24).
FIG. 24
3
FIG. 22
2
1
2. Loosen the four screws (3) inside each rail so that
the rails may be adjusted.
-17-
FIG. 23
LOCK KNOB
ZERO SCALE
Publicidad
