Selecting The Anchors; Assembly; Operating Manual; Lifting The Vehicle - Nussbaum SPRINTER MOBIL 2500 Instrucciones De Servicio

4.4

Selecting the anchors

• Liebig anchor without floor cover (screed)
Safety anchor with threaded bolts and nuts
BM 10-15/70/40
• Liebig anchor with floor cover (screed)
Safety anchor with threaded bolts and nuts
BM 10-15/70/xx (length of the anchor depends on the floor covering)
• Fischer anchor without floor cover (screed)
High quality anchor FH II-B (bolts and nuts)
FH II 15/50 B
• Hilti anchor without floor cover (screed)
Heavy duty anchor
HSL-3-G M10/40
• Hilti anchor without floor cover (screed)
Heavy duty anchor
Hilti HIT-V-5.8/M10/130
i
Similar value anchors and other known brands of anchor manufactu-
rers can be used when considering the conditions.
4.5

Assembly

i
Follow the instructions enclosed in the anchor packaging.
5

Operating manual

When handling the system, it must absolutely comply
with safety regulations. Carefully read the safety regu-
lations in Section 3 before first operation!
To prevent operation by unauthorized people, secure
the main switch (2) after working height has been rea-
ched.
3
2
4
Operating element
2 Main switch 3 „LIFT" button
For SPRINTER MOBIL - HYMAX PRO lifts, the motor of the
vehicle supported must always be on the fixed bearing
side, otherwise the vehicle could fall.
The total centre of mass of the vehicle and its load must
be between 100 mm and 600 mm away from the fixed
bearing towards the middle of the lift, otherwise the ve-
hicle could fall.
30
Slowly drive the vehicle to the middle in both the lengthwise and crosswise
directions over the drive-in rails.
Vehicle with front-wheel drive:
Vehicle with rear-wheel drive:
011
5.1

Lifting the vehicle

007
!
Warning! The hydraulic lines may not be driven over. This can lead to
4 „LOWER" button
damage and, if leaks result, even to the lift sinking.
!
The total centre of mass must be considered.
i
If required, use the ramps for safe acceptance of the vehicle.
• Secure the vehicle against rolling; pull the hand brake, engage the ge-
ars.
Version 1.0
Der
muss zwischen 100 und 600
mm zur Hebebühnenmitte
hin vom Festlager entfernt
sein
Festlager
SP = Schwerpunkt
Festlager
Der
muss zwischen 100 und 600
mm zur Hebebühnenmitte
hin vom Festlager entfernt
sein
Festlager
SP = Schwerpunkt
Festlager
Der
muss zwischen 100 und 600
mm zur Hebebühnenmitte
hin vom Festlager entfernt
sein
SP = Schwerpunkt
Festlager
20110005 SPRINTER MOBIL 2500-3000 - HYMAX PRO 2500-3000 OPI
Gesamtschwerpunk
008
Gesamtschwerpunk
009
Gesamtschwerpunk
010