Publicidad
Idiomas disponibles
Idiomas disponibles
en
ENGLISH
Do not exert excessive pressure on the saw blade
when working. The saw blade may slip or break if
excess pressure is exerted.
Do not slow down the saw blade after switching off
the tool by pressing it against the side of the
workpiece. Otherwise the saw blade may break or
cause a rebound. There is a risk of injury in this
case.
3.1
Special safety instructions for cordless
tools:
Remove the battery pack from the tool...
- ...before making any adjustments, changing tools,
maintaining or cleaning.
- ...if the operator moves away from the tool.
- ...prior to the removal of blockages.
- ...after touching a foreign body in order to check
the tool for damage.
- ...for immediate checking when the tool starts to
vibrate excessively.
Avoid unintentional starting: Make sure that the tool
is switched off before fitting the battery pack.
Protect battery packs from water and
moisture!
Do not expose battery packs to fire!
Do not use faulty or deformed battery packs!
Do not open battery packs!
Do not touch or short circuit battery pack contacts!
A slightly acidic, flammable fluid may leak
from defective Li-ion battery packs!
If battery fluid leaks out and comes into
contact with your skin, rinse immediately
with plenty of water. If battery fluid leaks out
and comes into contact with your eyes, wash them
with clean water and seek medical attention
immediately!
Additional Warnings:
WARNING
drilling, and other construction activities
contains chemicals known to cause cancer,
birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products, and
• Arsenic and chromium from chemicallytreated
lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are
specially designed to filter out microscopic
particles.
SYMBOLS ON THE TOOL:
V...............volts
.......... direct current
8
California Prop 65 08_2018
Some dust created by power
sanding, sawing, grinding,
4. Overview
See pages 2 and 3.
1 Clamping lever for tensioning the saw blade
2 Battery pack release button
3 Battery pack *
4 Capacity and signal indicator *
5 Capacity indicator button *
6 Allen key
7 Front handle
8 Locking button
9 Trigger
10 Rear handle
11 LED light
12 Guide rollers
13 Parallel guide
14 Saw blade *
15 Nut (2x)
16 Adjusting screw (2x)
17 Saw blade protection plate
18 Hanging hook
19 Pulleys
20 Rubber tyres
* depending on equipment / not included in the
delivery
5. Assembly,
Initial Operation and Setting
Remove the battery pack from the tool before
any adjustments, conversions, servicing or
cleaning are performed. Make sure that the tool is
switched off before fitting the battery pack.
5.1
Battery pack
Charge the battery pack (3) before use.
Recharge the battery pack if performance
diminishes.
The ideal storage temperature is between 10°C and
30°C.
"Li-Power" Li-ion battery packs have a capacity and
signal indicator (4):
- Press the button (5); the LEDs indicate the charge
level.
- The battery pack is almost flat and must be
recharged if one LED is flashing.
Inserting the battery pack
Removing: Press the battery pack release button
(2) and pull the battery pack (3) forwards.
Inserting: Slide in the battery pack (3) until it
engages.
5.2
Fitting and removing the saw blade
Remove the battery pack from the tool before
any adjustments, conversions, servicing or
cleaning are performed. Make sure that the tool is
switched off before fitting the battery pack.
Publicidad
