Floor Mounting - aldes Dee Fly Instrucciones De Montaje

FlOOr MOUntinG

Prohibited assemblies
Be careful that the direction of the exchanger and motor are correct!
Whether in an assembled or dissociated configuration,
the exchanger and motor must always be in the same
position to each other.
Floor-mounting
• Compulsory option: Dee Fly floor-
mounting kit. Plan for one kit per
casing (code 11023144)
• Feet mounted on each end of the
casing using screws (supplied)
• Anti-vibration mounts are used
to separate the motor from the floor
to limit the transmission of noise
• Screw the condensate discharge
to the heat-exchanger release
• Glue the bend to the white part
• Assemble the water trap to the bend.
This water trap runs without any
water. Be carreful to the direction
(arrow)
26
Wall MOUntinG (horizontal/vertical)
Horizontal wall mounting of the heat exchanger
• Compulsory option: Dee Fly floor-mounting kit. Plan for one kit per casing (code
11023144)
• Compulsory option: condensate evacuation kit for horizontal wall mounting
• Feet mounted on each end of the casing using screws (supplied)
• Anti-vibration mounts are used to separate the motor from the wall to limit
the transmission of noise
• Install the condensate recovery
delivered with the condensate evacuation kit for horizontal wall mounting
(code 11023099)
• Screw in the condensate evacuation nozzle
• Glue the bend to the white part
• Assemble the water trap to the bend. this water trap runs without any water.
Be carreful to the direction (arrow)
Prohibited assemblies
Vertical mounting of the exchanger
• Compulsory option: Dee Fly floor-mounting kit.
Plan for one kit per casing (code 11023144)
• Feet mounted on each end of the casing using screws (supplied)
• Anti-vibration mounts are used to separate the motor from the wall to limit
the transmission of noise
• To allow for the evacuation of condensates, fit a T-piece and purge plug to
the exchanger evacuation
• Add the condensate evacuation kit for vertical wall mounting
(code 11129790)
27
tank as described in the instructions
Be careful that the direction
of the exchanger and motor
are correct! Whether in an
assembled or dissociated
configuration, the exchanger
and motor must always
be in the same position
to each other.
Prohibited assemblies
Be careful that the direction
of the exchanger and
motor are correct! The
motor must not be placed
above or below the
exchanger.