Maintenance & Servicing - Stuart SC6 Serie Instrucciones De Funcionamiento

a red LED spot at the top left hand corner of the
display will be visible:
Figure 5: Active averaging facility on the SC6
To resume counting press the <average> key
again. When the count is complete, press and
hold the <correct/reset> key until the display
returns to zero. This will clear the memory of
saved counts.
When all counting is completed switch the unit
OFF at the mains.
Turning the audible counting bleep
ON or OFF
Turn the unit off at the mains ON/OFF switch.
Hold the <save> key down and switch the unit
ON at the mains ON/OFF switch.
Select either 'ON' or OFF using the
<correct/reset> key.
To confirm, press the <average> key.
The colony counter is now ready to use.
To turn the bleep on, repeat steps 1 to 5.
Cleaning the receiver plate
The receiver plate can easily be removed for
cleaning.
To remove, make sure that the instrument is
switched off at the mains. Tip the colony counter
upside down to remove the plate. Clean the plate
using a damp cloth only. Once cleaned the plate
should be returned to the colony counter.
Replacement plates are available (see Spares and
Accessories section).
Maintenance & Servicing
WARNING: Ensure the unit is
disconnected from the mains electricity
supply before attempting maintenance or
servicing.
Periodically clean the instrument using a damp
cloth and mild detergent solution. Do not use
harsh or abrasive cleaning agents.
Any repairs or replacement of parts MUST be
undertaken by suitably qualified personnel.
Spares and Accessories
The following spares and accessories are available
from your laboratory dealer:
Description
x1.7 magnifier
x3 magnifier
Wolffhuegel graticule
& segmentation disk (pack of 10)
Centering adapter (pack of 2)
Clear protective discs (pack of 10)
Receiver plate
For a comprehensive list of parts required by
service engineers conducting internal repairs,
please contact the Sales Department at
Barloworld Scientific Ltd quoting both the model
and serial number.
Only spare parts supplied or specified by
Barloworld Scientific Ltd. or its agents
should be used. Fitting of non-approved
parts may affect the performance and
safety features designed into the
instrument.
If in any doubt, please contact the Technical
Service Department of Barloworld Scientific Ltd.
or the point of sale.
Barloworld Scientific Ltd.
Stone, Staffordshire ST15 0SA
United Kingdom
Tel: +44 (0) 1785 812121
Fax: +44 (0) 1785 813748
e-mail equipment@barloworld-scientific.com
www.barloworld-scientific.com
Catalogue
Number
SC6/1
SC6/1/3
SC6/2
SC6/3
SC6/4
SC6/5
3