Troubleshooting - Yukon Signal N320RT Manual De Instrucciones

13
TRIPOD MOUNT
The standard ¼" tripod mount (10) in the lower part of the monocular is designed to install the unit on
a tripod.
14
OPERATING HINTS
When using the unit in the daytime at elevated illumination level, we suggest that you do not remove
the lens cover. The light filter built in the cover reduces image brightness thus enhancing the comfort
of observation.
When the unit is brought into a warm place after use in cold conditions, leave it in the carry case for 2-3
hours - this will help prevent condensation on the optics.
Do not leave the unit in direct sunlight.
Avoid exposing the unit to severe impact, thermal shock, aggressive liquids or other effects that are liable
to cause damage.
The unit is not water-resistant!
15
MAINTENANCE AND STORAGE
The optics should only be cleaned when it is necessary to do so. Use a soft cotton cloth and special multi-
coated lens cleaners.
Wipe plastic and metal surfaces with a soft cloth moistened with a synthetic cleaning agent.
Store the unit in its carrying case in a dry well-ventilated area. Remove the batteries when storing the unit
for an extended period.
19
16

TROUBLESHOOTING

The table below lists some potential problems that may occur when using the unit. If the problem
experienced with the unit is not listed, or if the suggested action does not resolve the problem, returned it
for repair.
Problem Check
Check that the batteries are correctly
The unit will not turn on.
fitted in the battery compartment.
Check battery operation.
Oxidized contacts in the battery
compartment due to "leaky" batteries
or contacts have been exposed to
a chemically active liquid.
The unit does not Make sure your power supply Is
providing output voltage.
operate on external
power supply.
Poor image quality. Check that the eyepiece and lens are
adjusted in accordance with the user
manual.
Make sure the lenses are not misted or
soiled.
Corrective action
Replace the batteries or fit the batteries correctly.
Clean the battery compartment, clean the
contacts.
Charge the external power supply (if required).
Check that the USB cable is intact.
Adjust the unit according in accordance with the
user manual.
Clean the lenses with a cloth moistened with
alcohol.
20