Resetting The System; Manual Mode - Ibiza sound LC192DMX Manual Del Usuario

3.1.4 RESETTING THE SYSTEM

Warning: This will reset the controller to its factory defaults. This will erase all
programs and settings.
1) Turn off the unit.
2) Press and hold BANK UP and AUTO/DEL.
3) Turn on power to the unit (while still holding BANK UP and AUTO/DEL).
3.1.5 COPY SCANNER
1) Press and hold SCANNER button # 1.
2) While holding button # 1 press SCANNER button # 2.
3) Release SCANNER button # 1 first before releasing SCANNER button # 2.
4) All SCANNER LED indicators will flash to confirm successful copy.
3.1.6 FADE TIME ASSIGN
You can choose whether the board s fade time during scene execution is
implemented broadly to all output channels or only to the Pan & Tilt movement
channels. This is relevant because often you will want gobos and colors to change
quickly while not affecting the movement of the light.
1) Turn OFF the controller.
2) Hold the BLACKOUT and TAPSYNC DISPLAY buttons simultaneously
3) Turn ON the controller.
4) Press the TAPSYNC DISPLAY button to toggle between the two modes. Either all
channels (A) or select channel Pan & Tilt only (P)
5) Press BLACKOUT and TAPSYNC DISPLAY to save settings. All LEDs will blink to
confirm.
3.2 Operation

3.2.1 MANUAL MODE

The manual mode allows direct control of all scanners. You are able to move them
and change attributes by using the channel faders.
1) Press the AUTO DEL button repeatedly until the MANUAL LED is lit.
2) Select a SCANNER button.
3) Move faders to change fixture attributes. TAPSYNC DISPLAY button: Press to toggle
the output indicator on the LED display between DMX values (0-255) and percentage
(0-100)
3.2.2 REVIEW SCENE OR CHASE
This instruction assumes that you have already recorded scenes and chases on the
controller. Otherwise skip section and go to programming.
SCENE Review
1) Select any one of the 23 banks by pressing the BANK UP/DOWN buttons.
2) Select a SCENE button (1~8) to review
©Copyright Lotronic 2014 Manual LC192DMX 7