Before First-Time Use; Before First Use / How To Check The Coding - IBP TD 4222 Manual De Instrucciones

before first-time use

Before you use the measurement system for the first time, feed the check/code
strip into the device until the code number is shown in the display (Fig. 2). Then
pull the check/code strip out again. The display will then show "OK" (Fig. 3). This
shows that the system is now calibrated and that you can start the test.
how to check the coding
1. Feed the test strip into the device when switched off (Fig. 1) to switch it on.
The display will show "CHK" and the "Test strip" symbol. After this, the sur-
rounding temperature is displayed, and then the code number is shown for
three seconds.
2. Compare the code number displayed with the code number on the test strip
container (Fig. 4). If the code numbers are the same, you can start the blood
sugar test. If this is not the case, please proceed as described above ("before
first-time use").
Note: Every time you open a new container of test strips, the device must be cali-
brated by feeding in the new check/code strip.
calibrating the device 7
( Fig. 2)
( Fig. 3)
( Fig. 4)
11