Publicidad
Idiomas disponibles
Idiomas disponibles
Making joints larger than the drilling template
Work procedure is shown in (Fig. 7).
Once the end stop is removed, the system can be moved along the edge of the work piece.
The centering pin is used to hold the last hole and keep 32mm spacing. The system is delivered with
an 8mm centring pin. The procedure is the same for drilling with the side stop; the system's position
on the work piece is ensured by the centring pin.
Fig. 7
WARNING!!!
While drilling, press the chuck adaptor against the drilling template to ensure vertical drilling.
The drilling bush can be supported with the other hand. Always keep the drill in a vertical position
so that the drilling bush touches the template surface with its entire surface. It is advisable to drill
holes gradually. Always follow safety instructions for drilling work!
www.cmtorangetools.com
CMT400-1
d=8mm
A
d=8mm
B
MAKING DOWEL JOINTS
EN
9
Publicidad
