Technical Features; Power Saving Function; Preset Modes; Damper Wires - Sun 21-Inch Premium Manual De Instrucciones

Technical Features

Power Saving Function

This monitor meets the power-saving guidelines set by
VESA and Energy Star, as well as the more stringent
NUTEK .
In particular, the monitor is capable of entering a low power
state when it is inactive and used with an Energy Star
capable framebuffer and appropriate Sun system software.
Power consumption
mode
Normal operation
1
Standby (1st mode)
2
Suspend (2nd mode)
3
Active-off (3rd mode)
4
Power-off
5

Preset Modes

Resolution Horizontal
(dots × lines)
Mode Frequency
1280 × 1024
1 81.1 kHz
1152 × 900
2 71.8 kHz

Damper Wires

When viewing a white background, very thin horizontal
lines may be visible on the screen as shown below. These
lines are the shadows of the damper wires and are
characteristic of CRTs that use aperture grilles. The wires
are attached to the aperture grille on the inside of the
Trinitron tube and prevent the vibration of the aperture
grille.
Damper wires
Screen Horizontal
Vertical
sync signal sync signal
active present present
blank absent present
blank present absent
blank absent absent
— — —
Vertical
Frequency
76Hz
76Hz
Getting Started
You can set the delay time before the monitor enters the
power saving mode using the OSD. Set the time according
to "Setting the power saving delay time" on page 15.
Note
If no video signal is input to the monitor, the "NO INPUT
SIGNAL" message (page 18) appears. After the delay time has
passed, the power saving function automatically puts the monitor
into the active-off mode and the u indicator lights up orange. Once
the horizontal and vertical sync signals are detected, the monitor
automatically resumes its normal operation mode.
Power
Recovery time
consumption
≤ 160 W
—
≤ 100 W
Approx. 3 sec.
≤ 15 W
Approx. 3 sec.
≤ 5 W
Approx. 10 sec.
—
< 1.0 W
Plug & Play
This monitor complies with the DDC™1, DDC2B, DDC2AB
and DDC2B+ Display Data Channel (DDC) standards of
VESA.
When a DDC1 host system is connected, the monitor
synchronizes with the V. CLK in accordance with the VESA
standards and outputs the EDID (Extended Display
Identification Data) to the data line.
When a DDC2B, DDC2AB or DDC2B+ host system is
connected, the monitor automatically switches to the
appropriate standard.
DDC™ is a trademark of the Video Electronics Standard
Association.
Technical Features
u indicator
Green
Green and orange
alternate
Green and orange
alternate
Orange
Off
17
EN
F
ES
C