Precautions - Sun 21-Inch Premium Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 99
Getting Started
Getting Started

Precautions

Installation
• Prevent internal heat build-up by allowing adequate air
circulation. Do not place the monitor on surfaces (rugs,
blankets, etc.) or near materials (curtains, draperies) that
may block the ventilation holes.
• Do not install the monitor near heat sources such as
radiators or air ducts, or in a place subject to direct
sunlight, excessive dust, mechanical vibration or shock.
• Do not place the monitor near equipment which generates
magnetism, such as a transformer or high voltage power
lines.
Maintenance
• Clean the cabinet, panel and controls with a soft cloth
lightly moistened with a mild detergent solution. Do not
use any type of abrasive pad, scouring powder or solvent,
such as alcohol or benzine.
• Do not rub, touch, or tap the surface of the screen with
sharp or abrasive items such as a ballpoint pen or
screwdriver. This type of contact may result in a scratched
picture tube.
Warning on power connection
• Use an appropriate power cord for your local power supply.
115 Volts
230 Volts
(not provided on standard
cord set)
CEE-22 cord set, female
end (all power cord
sets)
• Before disconnecting the power cord, wait at least 30
seconds after turning off the power to allow the static
electricity on the CRT display surface to discharge.
The outlet should be installed near the equipment
and be easily accessible.
4
United States,
Canada, Taiwan,
Korea, Japan
Continental Europe
Plug Type
Plug Type
NEMA S-15P
CEE 7/VII(Schuko)
Cord Type
Cord Type
SJT
HAR (HO5VV-
F3G1.0)
Min. cord set rating
Min. cord set rating
10 A/125 V
10 A/250 V
18/3AWG
Cord Length
Cord Length
(+/– 0.1 m)
(+/– 0.1 m)
2 m
2.5 m
Safety Approval
Safety Approval
UL/CSA
HAR
Autoranging universal power supply works anywhere; the monitor self-adjusts if the
appropriate power cord and plug for the local voltage are used.
Transportation
When you transport this monitor for repair or shipment, use
the original carton and packing materials.
Use of the Tilt-Swivel
With the tilt-swivel, this monitor can be adjusted to the
desired angle within 180° horizontally and 20° vertically.
To turn the monitor vertically and horizontally, hold it at
the bottom with both hands as illustrated below.
15°
90°
United Kingdom,
Ireland
Plug Type
B S 1363
Cord Type
HAR (HO5VV-
F3G1.0)
Min. cord set rating
10 A/250 V
Cord Length
(+/– 0.1 m)
2.5 m
Safety Approval
BSI, ASTA
• After the power has been turned on, the CRT is
demagnetized (degaussed) for about 3 seconds. This
generates a strong magnetic field around the metal frame,
which may affect the data stored on magnetic tapes and
disks near the bezel. Place magnetic recording equipment,
tapes and disks away from this monitor.
90°
Australia,
New Zealand
Plug Type
SAA AS 3112
Cord Type
CDB03PLP
Min. cord set rating
10 A/250 V
Cord Length
(+/– 0.1 m)
2.5 m
Safety Approval
Dept. of Energy of
New South Wales

Publicidad

Tabla de contenido
loading

Tabla de contenido