Levelling; Operation - Proline DWP 1247 WH Manual De Instrucciones

Water Pressure
For best operating results, incoming water pressure should be between 0.04 MPa and
1MPa. Incoming water supply for the dishwasher is controlled by a 'pressure switch', so if
the household water pressure is low, dishwasher fill time will increase or may not operate.
WARNING: Please close the hydrant after using.
Connecting to the water outlet
Insert the drain hose into a drainage pipe or standpipe.
The end of the hose should be dropped into a drainage pipe, the maximum height of which
should be 1000 mm above the base of the dishwasher. The end of the hose must not be
immersed in water to avoid the back flow of it.
To allow for an air gap around the end of the drain hose, the diameter of the standpipe
should be at least 40 mm.
If leaks are detected, immediately shut the water supply and check the hose connections
fully. Re‐tighten the connections if necessary.
If for any reason you are unable to stop the leak yourself please seek advice from a
qualified plumber.
Levelling
Place the dishwasher on an even, stable surface.
It is very important that the dishwasher is perfectly levelled in order to avoid the
dishwasher to malfunction. You can level the dishwasher by adjusting the base feet.
OPERATION
Your dishwasher cleans by spraying a mixture of clean water and detergent (under
pressure) against the soiled surface of dishes. The water is pumped through a rotating
spray arm, drained through a filter removing food and soiled particles and pumped back
through the spray arm.
Soiled water is pumped out and replaced with clean water at the end of each cycle (the
number of times depends on the cycle being used).
7