Troubleshooting - Proline DWP 1247 WH Manual De Instrucciones

TROUBLESHOOTING
Problem Possible Causes
Dishwasher Fuse blown, or the
will not start. circuit breaker
tripped
Power supply is not
turned on.
The door has not
been properly
closed.
Water not Kink in drain hose
pumped from
Filter clogged
dishwasher
Kitchen sink clogged
Suds in the tub Improper detergent
Spilled rinse aid
Stained tub Detergent with
interior colourant is used.
White film Hard water minerals
over the inside
surface
Solutions
Replace fuse or reset circuit breaker.
Remove any other appliances sharing
the same circuit with the dishwasher.
Make sure the dishwasher is turned on
and the door is closed securely.
Make sure the power cord is properly
plugged into the wall socket.
Close the door securely.
Check drain hose.
Check the filters (see "Cleaning the Filter
Unit").
Check kitchen sink to make sure it is
draining well. If kitchen sink is not
draining, you may ask a plumber to
check it.
Use only the detergent special for
dishwasher to avoid suds. If this occurs,
open the door and let the suds
evaporate. Close the door securely then
start the soak wash cycle to drain the
water out. Repeat if necessary.
Always wipe up rinse aid spills
immediately.
Make sure the detergent does not
contain any colourant.
To clean the interior, use a damp sponge
with dishwasher detergent and wear
rubber gloves.
Never use any other cleaner than
21