Remote Control - LaserLiner PowerCross-Laser 8 S Manual De Instrucciones

Remote control

A
B
C
Use of lithium-ion rechargeable battery
1
Before using the laser for the first time, insert
the battery in the device and fully charge (at
least 6 hours). Connect the battery charger to
charge the battery. The LED of the battery pack
lights red while the battery is charging. When
the LED changes to green, charging is complete.
When the laser lines blink slowly, the battery
is low. In that case, recharge the battery. The
rechargeable battery can either be charged
when it is not inserted in the device or when
the device is in use.
– The battery may only be charged with the battery charger provided
and used only in this laser device. Any other use may cause injury
or fire.
!
– Make sure there are no conductive objects in the vicinity of the
battery contacts. Short-circuiting of these contacts can cause burn
injuries or fire.
– Do not open the rechargeable battery. This could cause short-circuits.
Insert batteries into
the remote control
– Observing the correct polarity.
PowerCross-Laser 8 S
A Horizontal laser lines
D
B Vertical laser lines
C auto/man function /
E
Incline X/Y axes
F
D Infrared signal emitter
E LED status indicator
G
F Hand receiver mode
H
G Move X/Y axes
H Move X/Y axes
15
GB