LaserLiner Cubus Manual De Instrucciones página 20

Laser modes
Rotary mode
The following speeds can be set using the rotary
button: 0, 30, 330, 600 rpm
Spot mode
You access spot mode by pressing the rotary
button repeatedly until the laser stops rotating.
The laser can then be rotated to the required
position using the positioning buttons.
Scan mode
The scan button can be used to activate and
set a lightintensive segment in 4 different
widths. You position the segment via the
direction buttons.
Hand receiver mode
Working with the laser receiver (available as an
optional extra): Set the rotary laser to maximum
speed and switch on the laser receiver. Refer to
the operating instructions for the respective laser
receiver about this.
Working with the reference laser
The device has one reference laser. In vertical
mode the reference laser is used to align the
device. Align the reference laser parallel to the
wall for this purpose. This aligns the vertical laser
plane at a right angle to the wall, see illustration.
20
EN