Parts And Components; Before Use - cecotec Cumbia CAFELIZZIA 790 STEEL Manual De Instrucciones

Ocultar thumbs Ver también para Cumbia CAFELIZZIA 790 STEEL:
Tabla de contenido

Publicidad

ENGLISH

1. PARTS AND COMPONENTS

1. Tank cover
2. Water tank
3. Steam dial
4. Control panel
5. Cup tray
6. Steam Tube
7. Drip tray
8. Filter for 1 coffee
9. Filter for 2 coffees
10. Filter holder
11. Portafilter
12. Measuring spoon and coffee tamper
13. Steam button
14. 2 espresso/double espresso button
15. 1 espresso button
16. Power button

2. BEFORE USE

Take the product out of the box and remove all packaging materials, stickers, etc.
Make sure all parts and components are included and in good conditions. If any visible signs of
damage are observed, contact the Technical Support Service immediately.
First cleaning
Fill the water tank with water. The water level should not exceed the "MAX" mark in the tank.
Insert the filter in the funnel and assemble the portafilter into place. Ensure the portafilter is
aligned with the lock drawing to ensure it is safely assembled.
Fig. 2.
Plug the device into a power supply and press the power button. The machine will beep. The 1
espresso and 2 espresso light indicators will turn on and the machine will start heating.
Once the 1 espresso and 2 espresso light indicators remain steady, press the 1 espresso button.
The machine will start the cleaning process. Make sure the steam extraction knob is off. If it is
not, the 4 light indicators will turn on and the machine will not work.
Note: If you want to carry out a more thorough cleaning cycle of the inside parts of the device,
use a 1:4 solution of vinegar and water, or use descaling product. Repeat this process just with
water to remove any rests.
CAFELIZZIA 790 STEEL/SHINY/WHITE/BLACK
32
3. OPERATION
Fill the water tank without exceeding the MAX mark.
Connect the coffee machine to a power supply and make sure the steam knob is set at the off
position.
Espresso
While the machine preheats, place the desired coffee filter in the portafilter and fill it with
coffee powder. Use the measuring spoon/coffee tamper to pour and press coffee down. 1
tablespoon is equal to 1 coffee dose. Clean the excess coffee from the filter's edge.
Fig. 3.
Insert the portafilter in the device and lock it tightly.
Fig. 4.
Once the 1 espresso and 2 espresso light indicators switch from blinking to steady, press the
desired coffee button for the machine to brew 1 or 2 coffees.
Note: Make sure you have previously placed an appropriate cup or cups under the coffee spout.
Milk froth
Press the power button first. Then, press the steam button. The steam light indicator will
remain steady on when it has completed the preheating process.
Pour milk into the container where you want to froth milk. Fill 1/3 of it.
Recommendation: It is recommended to use cold whole milk for optimal results.
Release some steam before using it to froth milk. Once the tube has produced some steam,
switch off the function, insert the steam tube 1 cm into the milk and slowly turn the steam knob
anticlockwise until steam starts being released.
Fig. 5.
1. Off
2. Steam/water
Note: The steam tube might emit some water droplets before producing steam.
When milk temperature starts to rise (to up to 75 ºC) and milk froth volume starts increasing,
turn the steam knob clockwise to the 0 position and press the steam button to stop the steam
function.
Warning: Clean the steam exit with a wet sponge immediately after use. Then, remove the
steam tube and clean the duct's inside part. It is also recommended to emit steam again in
ENGLISH
CAFELIZZIA 790 STEEL/SHINY/WHITE/BLACK
33

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido