Lacor GOURMET Instrucciones De Uso página 46

9.- TEMPERATURE: When you press the "HEAT" button (a), the colour of the button will change
from red to blue and it will flash. Move the temperature / time regulator (2) to set the
temperature between 20-100°C. Once selected, the regulator wheel will flash red for
3 seconds. When the wheel turns white, the temperature has been set. The "HEAT" button will
turn blue on this occasion (permanent).
10.- TIME: When you press the "TIME" button (d), the colour of the button will change from red
to blue and it will flash. Move the temperature / time regulator (2) to set the time up to
a maximum of 99 hours. First select the hours, then press "TIME" (d) to select the minutes.
Once selected, the regulator wheel will flash red for 3 seconds. When the wheel turns white,
the time has been set. The "TIME" button will turn blue on this occasion (permanent).
11.- Press the ON/OFF button (b) and the product will start working (the button will change from
red to blue). When the water temperature on the indicator (e) reaches the set temperature,
the time will begin to count down. If you want to cancel the process, press the ON/OFF
button (b) at any time.
12.- A "beep" sound indicating the end of the work process will let you know that the programmed
time has elapsed.
CALIBRATED
If you spot that the product's temperature measurement is out of sync or unrealistic, follow the
steps below to calibrate the product:
1.- Measure the water temperature with an external thermometer which has already been
calibrated beforehand to ensure that the measurement to be performed is accurate.
2.- Compare this value with the temperature shown on the machine's display.
3.- If there is a difference of over 1°C, press the "HEAT" button for 5 seconds and enter the
calibration mode. Use the wheel until it reaches the value "1.0". Press the ON/OFF button
to confirm.
46