5. S2 INSTALLATION
(See section 6 for C3PRO installation instructions)
5.1 REMOVING THE EXISTING ACOUSTIC COLLAR
First,.remove.the.existing.Acoustic.Collar.from.your.helmet.as.follows:
Pull.out.and.remove.the.Acoustic.Collar.from.the.front.at.its.bent.center.
5.2 CONNECTING THE ANTENNA CABLE
Your.SRC-System™.has.an.antenna.cable.which.must.be.connected.to.the.built-
in.antenna.cable.connector.in.the.Schuberth.helmet.
.
NOTE: Make sure to close the cover of the USB
connector, and then tuck it away into
the USB connector pocket.
1.. Pull.out.the.antenna.connector.(marked.with.a.red.tag).which.is.tucked.inside.
the.back.rim.of.the.helmet.
Antenna tag visible
MAN00097 QG SRC-S2_C3 J 009.indd 31
Antenna connector
pulled out
2..
On.the.SRC.collar.open.the.two.fasteners.
on.the.antenna.connector.and.remove.the.
protective.plastic.cover.
3..
On.the.helmet.remove.the.rubber.
protector.from.the.antenna.
connector.
4.. Align.the.two.connector.heads.and.snap.the.two.fasteners.back.into.place.to.
lock.the.connector.in.a.closed.position..
5.. The.antenna.connector.can.now.be.
safely.stowed.away.inside.the.antenna.
connector.pocket.on.the.center.of.the.
SRC-System™.
A.
B.
A.
B.
31
7/18/12 5:38 PM