Wearing.ANd.REmoving.THe.HElmet; Cleaning.THe.SRc-System™.ACoustic.COllar; C3.PRo.INstallation; Removing.THe.EXisting.ACoustic.COllar - SCHUBERTH SRC‑SYSTEM S2 Manual De Instrucciones

Ocultar thumbs Ver también para SRC‑SYSTEM S2:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

5.7 WEARING AND REMOVING THE HELMET
The.electronic.components.of.SRC-System™.are.safely.embedded.inside.an.
Acoustic.Collar..To.avoid.discomfort.while.you.put.on.your.helmet.or.while.
removing.it,.we.recommend.that.you.proceed.as.follows:.
1.. Expand.the.helmet.opening.by.firmly.holding.the.chin.straps.and.pulling.
them.forcefully.apart..
2.. While.pulling.the.straps.apart,.slide.the.helmet.
over.your.head.
3.. To.remove.the.helmet,.proceed.along.the.same.
lines.by.first.pulling.the.straps.apart.and.then.
pushing.the.entire.helmet.upwards.
NOTE: Your SRC-System™ Acoustic Collar is designed for maximum comfort.
However, since it contains an entire electronic kit within, it will have a slight a bulge.
Therefore, putting your SRC equipped helmet on or taking it off may feel different
than what you are used to with a standard Acoustic Collar. Remember: The more
you pull the helmet straps apart when putting on your helmet or taking it off, the
smoother the process will be, allowing the Acoustic Collar to soften.
5.8 CLEANING THE SRC‑SYSTEM™ ACOUSTIC COLLAR
To.clean.the.SRC-System™.Acoustic.Collar,.first.make.sure.the.USB.connector.is.
tightly.closed..Use.only.a.slightly.damp.cloth..Avoid.soaking.the.Acoustic.Collar.
with.water.or.any.other.fluid..Never.submerge.it.and.refrain.from.letting.water.
come.in.contact.with.the.speakers.or.the.microphone..Allow.the.unit.to.dry.at.
room.temperature.
MAN00097 QG SRC-S2_C3 J 009.indd 33
6. C3 PRO INSTALLATION
(See section 5 for S2 installation instructions)
6.1 REMOVING THE EXISTING ACOUSTIC COLLAR
First,.remove.the.existing.Acoustic.Collar.from.
your.helmet.as.follows:
1..Open.both.snap.buttons.
2... P ull.out.the.Acoustic.Collar.from.the.rear.at.
its.bended.center.
3... R elease.the.collar's.pins.from.their.
corresponding.indentations.inside.the.
helmet's.rim.
6.2 CONNECTING THE ANTENNA CABLE
Your.SRC-System™.has.an.antenna.cable.which.must.be.connected.to.the.built-
in.antenna.cable.connector.in.the.Schuberth.helmet.
NOTE: Make sure to close the cover of the USB
connector, and then tuck it away into
the USB connector pocket.
33
7/18/12 5:38 PM

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Src‑system c3

Tabla de contenido