Replacing The Lamp; Closing The Door - AEG SKS41240S0 Manual De Instrucciones

Problem
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.

REPLACING THE LAMP

CLOSING THE DOOR

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
Possible cause
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
The temperature regulator
is not set correctly.
1.
2.
3.
4.
5.
6.
7.
8.
Solution
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Disconnect the mains plug from the
mains socket.
Remove the screw from the lamp cov-
er.
Remove the lamp cover (refer to the
illustration).
Replace the used lamp with a new
lamp of the same power and specifi-
cally designed for household applian-
ces. (the maximum power is shown on
the lamp cover).
Install the lamp cover.
Tighten the screw to the lamp cover.
Connect the mains plug to the mains
socket.
Open the door. Make sure that the
lamp comes on.
ENGLISH
31