Troubleshooting Guide - Gorgy Timing RADIO TIMING CP09 Guia Del Usuario

SYMPTOMS
RTCP09 does not
switch on.
Cannot access the
web interface.
The relay outputs
are not switching.
The clocks
connected to the
RTCP09 are not
synchronized.
The RTCP09 does
not set itself to the
exact time.
MDE-RTCP09-3060V2.2
POSSIBLE CLAUSES
The power cable is
disconnected.
The network cable is not
correctly connected to the
RTCP09.
The RTCP09 has not obtained
an IP address.
The IP address used does not
correspond to the RTCP09.
No event has been scheduled
in the calendar manager.
Relay output defective.
Problem in time zone
configuration.
The RTCP09 is not configured
in UTC time. The outputs are
switching with one or more
hours of offset.
The outputs are deactivated.
The synchronization source is
not working.
The use of the internal clock is
forced.
7.

TROUBLESHOOTING GUIDE

SOLUTIONS
Connect the power cable to the mains
supply.
Check whether network cable is
connected properly with the RTCP09.
Use the menus in the front interfaces to
configure the IP address.
Use the menus in the front interfaces to
check the IP address.
Schedule an event in the calendar
corresponding to the concerned relay.
You can test the operation of the
outputs via the «Calendar» page in the
web interface or «Force relays» page
in the front interfaces.
Set the RTCP09's internal clock
correctly.
Connect to the web interface and check
whether the outputs are activated.
Check whether the synchronization
source is transmitting its signal.
In the web interface, «Time bases»
page, make sure that the «Force RTC»
box is not checked.
123