Gorgy Timing RADIO TIMING CP09 Guia Del Usuario página 66

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING! Read the section below very carefully before installing your equipment. It gives
the safety instructions that must be followed during installation.
To protect your equipment, connect power on UPS (Uninterruptible Power Supply).
The electrical installation to which the equipment is connected must comply with the NF C
15-100 standard.
This device does not have a primary power switch. A power protection system (circuit-brea-
ker or disconnecting switch), that is easy to access must be built into the wiring installation.
This device must withstand the nominal voltage and current values specified on the clock.
In Europe: To comply with European regulations on the protection of persons and the envi-
ronment, you must dispose of this equipment in a collection site provided for this purpose
(separately from household waste). Contact your reseller, collection site or the competent
local authorities for more information.
If the
RTCP09
may be discharged. To replace it, contact the Gorgy Timing Customer service department
(Contact details on the back of this manual)
Modifying or opening the product without the consent of the Customer service department
will void the warranty.
The
RTCP09
All maintenance operations should be carried out when the equipment is shut down; this is
also applicable to systems connected to any relay outputs.
In general, the power (220V) and signal (time information) cables should not be too close
to one another, to prevent interference. To avoid risk of electrical interference, move the
RTCP09
as far as possible radiation sources (speakers, antennas, high frequency equip-
ment, electromechanical rings ...).
Gorgy Timing declines any liability in the event of accidents or damages caused by an impro-
per use of RTCP09.
GORGY TIMING products comply with the following standards: CE, EN 60950, EN
55022, EN 50024.
66
IMPORTANT SAFETY INSTRUCTIONS
does not store the time in its memory after a power failure, the backup battery
should be installed, maintained and handled only by competent persons.
MDE-RTCP09-3060V2.2

Publicidad

Tabla de contenido
loading

Tabla de contenido